RHINO 1540 Instrukcja Operatora Pobierz pdf (Strona 56)

MAINTENANCE

1540 02/12 Maintenance Section 5-2

MAINTENANCE

Lubrication

The Rhino 1540 is a rugged, dependable Blade that

should perform satisfactorily with the following

preventive maintenance:

Lubricate the Moldboard Pivot Pin (Figure Mnt-

0002) and the Moldboard Tilt Pin (Figure Mnt-

0001) after every 10 hours of operation. Decals are

placed in locations about the implement indicating

locations of Grease Fittings.

Replace excessively worn Grader Blade when

ditching. A badly worn cutting edge increases the

strain on the Blade and the tractor and reduces

efficiency.

If the Gauge Wheel is used, a Grease Fitting is

provided at the Caster Pivot location, and on wheel

hub.

Proper Torque For Fasteners

The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to

this chart to determine the grade of bolts and the proper torque except when specific torque values are

assigned in manual text.

Recommended Torque in Foot Pounds Unless Otherwise Stated in the Manual*

NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine

oil. They do not apply if special graphitic or molydisulphide greases or other extreme pressure lubricants are

used. This applies to both UNF fine and UNC coarse threads.

1 2 ... 51 52 53 54 55 56 57 58 59 60

Brak uwag

RHINO 1540 Instrukcja Operatora Strona 56