RHINO 1540 Instrukcja Operatora Pobierz pdf (Strona 39)

OPERATION

1540 02/12 Operation Section 4-9

OPERATION

Connecting the Rear Blade

1. Shorten or remove the tractor drawbar to avoid

interference when raising and lowering the rear

blade.

2. Board the tractor and start the engine. Position

the tractor to the blade with the 3-point lift arms

positioned between the respective set of blade

A-frame lift lugs. Note: Set the 3-point lift

control to “Position Control” so that the lift arms

maintain a constant height when attaching the

blade. See the tractor Operator’s Manual for

correct settings when attaching 3-point

equipment.

3. Turn off the tractor engine, set the parking

brake, place the tractor in park, and dismount.

4. One lift arm at a time, align arm end hole

between the set of holes of A-frame lift lugs.

Insert hitch pin through the lug and arm holes

and insert retaining pin into hitch pin. Walk

around to opposite side and repeat procedure

for remaining lift arm and hitch pin.

5. Extend or retract the 3-point top link to align its

end hole with the holes of the blade’s top link.

Insert the top link pin and retain with hairpin.

6. Adjust any lower link check chains, guide

blocks, or sway blocks to prevent the blade

from swaying side to side and possible contact

with tractor rear tires.

Never work under the Implement, the framework, or any lifted

component unless the Implement is securely supported or blocked up

to prevent sudden or inadvertent falling which could cause serious

injury or even death.

(SG-14)

7. PRE-OPERATION INSPECTION AND SERVICE

Before each use, a pre-operation inspection and service of the implement and tractor must be performed.

This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped

and functional, and performing needed repairs. DO NOT operate the unit if the pre-operation inspection

reveals any condition affecting safe operation. Perform repairs and replacement of damaged and missing

parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable down time

and repair cost can be avoided. OPS-U-0029

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 59 60

Brak uwag

RHINO 1540 Instrukcja Operatora Strona 39